Read this model’s listing the way an installer reads it: the only protection-related line EVDANCE publishes for the EV-ACS3205PE is its IP66 enclosure rating — dust-tight, and sealed against powerful water jets. No RCD type, no DC fault detection, no surge or over-temperature device is named for this unit. That absence is not a gap to fill with assumptions. At 32 A three-phase, protection is a two-sided design: the charger’s enclosure on one side, the circuit feeding its socket on the other — specified by an electrician, not a product page.
Key Takeaways
- The only protection line published for this model is IP66 — an enclosure sealing grade, not an electrical protection.
- No RCD type, DC detection, surge or thermal behaviour is stated for this unit; unlisted means ask in writing, never assume.
- Most of the protection at a CEE socket is circuit-side, specified by the electrician who installed or verified that circuit.
- Never borrow a protection claim from another model’s datasheet — each listing stands alone.
What the Listing States — and What It Does Not
| Item | Stated for this model? | How to treat it |
|---|---|---|
| IP66 enclosure rating | Yes | Claimed — but it grades dust and water sealing of the housing, not electrical protection |
| Built-in RCD, of any type | Not stated | A written question for EVDANCE; never assume a type |
| DC fault detection | Not stated | A written question for EVDANCE |
| Surge protection inside the unit | Not stated | A written question; surge is also commonly a circuit-side decision |
| Over-temperature or other protective behaviour | Not stated | Do not credit the unit with behaviour its listing does not describe |
Two reading rules do the work. Listed means claimed: IP66 is a real, testable promise about the housing. Unlisted means ask: a protection that matters to your site belongs in the manual or in a written answer from the manufacturer. Never transfer a sibling’s line — another model’s datasheet says nothing about this one. Our explainer on RCD protection, Type A, Type B and 6 mA DC detection covers what those terms mean, so you can ask the questions precisely; our piece on whether an EV charger needs GFCI protection covers the same ground for North American readers.
The Circuit Side Is the Other Half
A portable charger plugs into a socket somebody else installed — and the protective devices for that circuit live in the site’s distribution board, chosen by the electrician who fitted or verified the socket under local wiring rules. That is where most of this unit’s protection story is written. Before relying on a site socket for regular 32 A charging, the questions are for the site and its electrician:
- What protects this circuit — which breaker and which residual-current device did the installer specify for it?
- Was the socket installed or verified for EV charging duty — hours of continuous load, not a brief machine run?
- What is the socket’s condition today: firm seating, no warmth or discoloration after a session, no damage to the housing?
None of these has a product-page answer. The IET Code of Practice for EV charging equipment installation is the reference installers work from; your electrician is the authority for your site.
The Unit Itself
The EV-ACS3205PE is a 22 kW three-phase portable charger: 32 A at 380–400 V, CEE 32 A five-pin plug, Type 2 connector, 1.77-inch display, IP66 housing. If a protection on your site’s checklist is not in that listing, put the question to EVDANCE in writing via the contact page before ordering. EVDANCE is a Shenzhen manufacturer founded in 2011; the model carries its 3-year standard warranty. One owner-level rule needs no written answer: warmth, discoloration or damage at the plug, cable or socket means stop, and have it checked before the next session.
Frequently Asked Questions
Does the EV-ACS3205PE have a built-in RCD?
Its listing does not say so. Treat any built-in RCD as unconfirmed until EVDANCE confirms it in writing, and plan on the circuit side: the RCD protecting the socket you use is specified by the electrician who installed or verified that circuit.
Is IP66 a safety certification?
No. IP66 is an ingress rating — it grades how the closed housing keeps out dust and water. It says nothing about fault currents, surges or disconnection. Electrical protection is a separate question, answered by the listing for the unit side and by your installer for the circuit side.
Can I use it on any 32 A CEE socket I find?
The plug will fit a 32 A five-pin CEE socket; whether that socket’s circuit is protected and conditioned for hours of EV charging is the site’s side of the design. For a socket you will use regularly, have an electrician confirm the circuit first.
Related Reading
- RCD Protection for EV Chargers: Type A, Type B and 6 mA DC Detection Explained
- Does an EV Charger Need GFCI Protection?
- Should EV Chargers Have Surge Protection?
- IP Ratings for EV Chargers: IP54, IP65 and IP66 Compared
