For the Middle East, sort the EVDANCE range by supply first and environment second. The three-phase Type 2 models are the core for sites with a three-phase supply; dust is answered by the IP ratings the listings state; heat is a siting question — shade, cover and clearance — because no EVDANCE listing publishes an operating-temperature rating, and that figure belongs in your written confirmation before an order.
Key Takeaways
- Sort by supply first: the three-phase Type 2 models are the core; the EV-ACS3210E covers single-phase sites.
- Dust is answered by stated IP ratings — IP66 models are dust-tight; IP54 stations belong in covered bays.
- No listing publishes a temperature rating; handle heat by siting, and get the figure in writing.
- Confirm the market version and the DC unit’s connector variant before ordering.
The Three-Phase Core
| Model | Stated facts | Where it fits |
|---|---|---|
| ACS1605PE | 11 kW three-phase portable, CEE 5-pin plug, Type 2, 7.6 m cable, IP66 | Sites with CEE 16A supply points |
| EV-ACS3205PE | 22 kW three-phase portable, CEE 32A plug, Type 2, IP66 | Sites with CEE 32A supply points |
| EV-ACT3204PE | 22 kW wallbox, Type 2, RFID and app, IP66, CE | Fixed bays where access control matters |
| EV-AC03201T | Dual-connector AC station, up to 43 kW shared, OCPP 1.6J, RFID, IP54 | Shared or public bays run on a platform |
| EV-RHDC30K-L | 22 kW DC fast charger, OCPP 1.6J, IP54 | Short-stay DC charging; its connector variant is not named in the listing — confirm it |
Where a site’s supply is single-phase rather than three-phase, the EV-ACS3210E is the stated single-phase portable: about 7 kW, Type 2, IP66, with app control. The supply at the actual site decides which half of the range is even a candidate — confirm it before comparing models.
Dust: Read the First Digit of the IP Rating
In the IP code, the first digit rates protection against solids, dust included: 6 is the dust-tight level and 5 means dust-protected, where some ingress is permitted but must not interfere with operation. Our explainer on IP ratings for EV chargers works through both digits. Applied to this range, the portables and the wallbox pair state IP66 or the IP65/IP66 pair — the dust-tight end — while the two stations state IP54. The practical consequence is siting: an IP54 station belongs in a covered bay, where the roof does the work its rating does not claim, and dusty sites should keep connectors off the ground and covered when idle as a matter of site routine. Our guide to IP ratings for portable chargers covers the driver side of the same code.
Heat: Siting, Because the Page States No Rating
Be clear about what the listings do not say: no EVDANCE product page publishes an operating-temperature range or any behaviour at high ambient temperatures. So heat is not a specification you can compare on paper — it is handled where it can be handled, in the installation. Chargers go in shade or covered parking rather than full sun where the site allows; the installer leaves the clearance the model’s manual specifies so air can move around the enclosure; and a unit that will live in an exposed, sun-baked bay is a question to raise in writing before ordering, not after commissioning. Our guide to hot-climate EV charging covers Gulf siting practice in depth.
Before You Order for the Region
- The market version of the model offered for your country, confirmed in writing.
- The model’s stated operating-temperature range, in writing — it is not on the product page.
- For the EV-RHDC30K-L, the DC connector variant, which its listing does not name.
- The certificates behind each model, as stated: CE for the EV-ACT3204E, and documents to request for models whose listings name no mark.
The full range is on the products page, and regional orders start with a conversation via contact us.
Frequently Asked Questions
Are EVDANCE chargers rated for Gulf summer heat?
No EVDANCE listing publishes an operating-temperature rating, so there is no figure to quote. Ask for the exact model’s stated range in writing before ordering, and site the unit in shade or cover in the meantime — siting is the part fully in your control.
Is IP54 enough for a dusty site?
IP54 means dust-protected, not dust-tight. An IP54 station is a covered-bay product: the roof and routine connector care do the rest. Where a unit must live exposed to dust, the models stating IP66 are the dust-tight option in this range.
Which EVDANCE models fit a three-phase supply?
The ACS1605PE and EV-ACS3205PE portables, the EV-ACT3204PE wallbox and the EV-AC03201T station are the three-phase models, with the EV-RHDC30K-L as the DC option. The EV-ACS3210E covers single-phase sites.
Related Reading
- Hot-Climate EV Charging: Protecting Chargers From Desert Heat and Sun
- IP Ratings for EV Chargers: IP54, IP65 and IP66 Compared
- CEE Plugs Explained: Choosing 16A or 32A for a Three-Phase Portable EV Charger
- Are Portable EV Chargers Waterproof? IP Ratings Explained for Drivers
